LED’s near the switches show the activated preset. LED’s near the sockets show which loops are activated in the preset used at the time. Programming is very simple to do using DIP switches placed on the top face of the controller (small block of 6, for each program – FX 1, 2, 3, 4 and channel switching). There are no processors or Flash memory so your settings cannot be lost.
Notice: Due to the high power consumption by the relays (approx. 240mA), it cannot be battery powered. But this is not a problem since you can power the unit from your pedalboard's power supply or, if you prefer, we can supply an appropriate power unit.
Examples of use:

	1. One effect (or set of effects) connected before the amp, three effects (or sets of effects) connected to the amp effects loop. Control over the amp channel socket.
	2. All effects (or sets of effects) are connected before the amp. Effects before the ProgLooper are activated independently, the others (connected to ProgLooper) are activated by the program switches. The volume pedal is placed between the first and second set of effects. Control over amp channel switching.

<< previous